Frog Arms, LLC

Gunsmithing Services: Trigger jobs: (Available for both pistols and rifles) Polishing Lightening trigger pull Set pre-travel, break, over-travel Competition setup Duty setup AR-15 piston installs Custom sight installs Stock refinishing Firearm Coating Firearm Restoration Custom Builds

Tisa Duty 1911  Performed a trigger job and polished the sear. Produced a clean, crisp break at 3lbs trigger pull with additional internal polishing, spring replacement, and tuning.

Competition Only Glock 19 Polished internals and installed a Timney trigger. After setting pre-travel and over-travel, it produced a 2lbs trigger pull.  Note: This low of a trigger pull should never be used in duty or concealed carry.

Ruger Mini-30 Polished all parts and replaced trigger spring with M*Carbo kit. This reduced trigger pull from the factory 6-lbs to a safe 2-lbs which the customer loved.

AR-15 Adam Arms Carbine piston and Samson Evolution® Series handguard  The handguard is specially designed to accommodate pistons under the top rail.    

Advantage Tactical Sights installed on Glock 20  These sights have been installed on Glocks, Smith & Wesson M&P, Springfield Armory XD-S, and more. Other brands of pistol and rifle custom sights can be installed.

M1A1 Stock Refinishing With Tru-Oil.  The original finish was stripped to bare wood. All dents and discolorations were removed, and a light walnut stain was applied to restore to the original color. Tru-Oil produced a rich gloss finish. It can also be tailored to a satin finish if the owner would prefer.  

DuraCoat 1959 bolt action shotgun restoration (bottom) using bluing-colored DuraCoat and tongue seed oil on the stock. Remington 1100 (top) was also coated with a bluing-colored DuraCoat.

DuraCoat on a Springfield Armory 1911 Coated with flat black DuraCoat on the slide and light grey on the frame. Additional internal parts swap includes Wilson Combat trigger, hammer, sear, disconnect, and sear spring. Externally, we changed the beaver tail grip safety and added Pachmayr wrap-around grips.

  Custom AR-15 Carbine  Stag Arms lower with S&W M&P upper, Adam Arms piston, Magpul pistol grip, and extending stock. The fire control group was replaced with Franklin Armory's BFSIII-ARc1 binary trigger. This build also included an ambidextrous selector and Magpul's BAD Lever extended bolt catch.